Frequently asked questions about ccie lab blue print

Headlines on ccie lab blue print

How to setup B-ACD so that CME phones and FXO ports can access it?

Fri, 28 Jul 2006 06:05:55 +0000
Usually you call the B-ACD application by matching the incoming dial-peer and calling the application using the service command. You can also set it so that you can call from IP Phones and FXO ports directly to AA application
dial-peer voice 10 voip
destination-pattern 1000 (this is the pilot number defined in AA)
codec g711ulaw
session-target ipv4:10.1.1.1 (use a ...]

This is In response to the comment posted:

The ACL has no direct relation to the CBAC firewall, it is there to prevent traffic coming into your network from the outside, the inspection rule is there to inspect traffic going out from your network. if the ACL was not there the traffic would have been inspected but still people would able to go into your network. so if you want to block traffic you must have ACL but if you inspect traffic then even if there is a deny statement on the outside interface traffic is allowed to return. so the short answer CBAC is not inspecting the ACL, CBAC is inspecting what you tell him on the inspection rule.

Thoughts About Online Privacy

Fri, 20 Jun 2008 14:26:28 +0000
Finding myself in the spotlight over the past couple of weeks has given me pause for thought.  Why was I lit up like I was?  One important part of that answer is that I purposely made myself easy to find.  My name isn’t that common, although googling my name comes up with an athlete (decidedly ...]

Callmanager - AD integration - Adding /Deleting users from CCM admin page

Fri, 21 Jul 2006 03:29:24 +0000
Step 1 Browse to C:\dcdsrvr\config, and open the file, UMDirectoryConfiguration.ini, in Notepad.


Caution You must open the file in Notepad. Opening the file in another text editor application may corrupt the file.


Step 2 In the UMDirectoryConfiguration.ini file, locate the key, UserDirAccess.

Step 3 Change the UserDirectAccess value to true.

Step 4 In Notepad, choose File > Save to save the file.

Step 5 Close ...]

VTP version 2 and vtp messages regardless domain name

Sat, 01 Mar 2008 18:39:21 +0000
This should work, but is i labbed it out, it does not as promised. Let`s say if you have a vtp domain CISCO and one switch, that is configured in transparent mode, does belong to another domain, does not forward, these vtp messages. If you have this one switch in between the others, your vlan ...]

Oracle raises prices significantly for some products

Calling All CCIE R&S Beta Testers

Mon, 26 May 2008 22:55:50 +0000
CCIE R&S Candidates,
We are in the process of updating our products (yet again ) in order to provide you all with the most relevant material for CCIE R&S preparation. The first item slated for release is a new format for our CCIE R&S Lab Workbook Volume I (Technology Labs). I am looking ...]


We have been very thorough in providing as much information on ccie lab blue print as possible in this article. Please use it to make our efforts fruitful.We have been very thorough in providing as much information on ccie lab blue print as possible in this article. Please use it to make our efforts fruitful.



ccie lab rentals
ccie lab routers
ccie lab scenario
ccie lab scenarios
cisco ccnp bootcamp | cisco ccnp bsci | cisco ccnp cbt